Understanding The Cable Management System, Cables, And Connectors - Juniper M Series Monitoring And Troubleshooting Manual

M Series and T Series Routers Monitoring and Troubleshooting Guide
Related
Documentation

Understanding the Cable Management System, Cables, and Connectors

352
Table 92: Checklist for Maintaining Cables and Connectors (continued)
Maintain Cable and Connector Tasks
"Cleaning the Transceivers" on page 361
"Checking the PIC Port Status" on page 361
1. Check the PIC or FPC LED Status on
page 361
2. Display the PIC Media Type on page 362
"Maintaining the Power Cables" on
page 363
"Maintaining Routing Engine External
Cables" on page 364
"Replacing the Cable Management
System" on page 364
The Cable Management System, Cables, and Connectors Overview on page 353
The Cable Management System, Cables, and Connectors Overview on page 353
M5 and M10 Router Cable Management System on page 353
M10i Router Cable Management System on page 353
M20 Router Cable Management System on page 354
M40 Router Cable Management System on page 354
M40e and M160 Router Cable Management System on page 355
M120 Router Cable Management System on page 356
M320 Router Cable Management System on page 356
T320, T640, and T1600 Router Cable Management System on page 357
TX Matrix Router Cable Management System on page 357
TX Matrix Plus Cable Management System on page 358
Command or Action
Follow all procedures in the cleaning kit you use.
See the appropriate router hardware guide and
the PIC hardware guide.
Check the PIC LEDs.
show chassis fpc pic-status
show chassis pic pic-slot numberfpc-slot number
Use the specified cables and connectors. Turn
power off to the router, then reconnect power
using the replacement cables.
Turn off the power switch, if necessary. Use the
specified cable and connector.
See "Return the Failed Component" on page
or follow the procedure in the appropriate router
hardware guide.
Copyright © 2012, Juniper Networks, Inc.
116,