Check The Redundant Mcs Status From The Craft Interface - Juniper M Series Monitoring And Troubleshooting Manual

Meaning

Check the Redundant MCS Status from the Craft Interface

Purpose
Action
Sample Output
Copyright © 2012, Juniper Networks, Inc.
8.0 V bias
CMB Revision
The
show chassis environment mcs
only. The command output displays environmental information about both MCSs installed
in the router or about an individual MCS. The MCS status can be
or Empty . The command also indicates that the MCS is the master MCS. The command
output also displays the temperature of the air flowing past the MCS, information about
MCS power supplies, field-programmable gate array (FPGA) revision information, and
the revision level of the chassis management bus (CMB) backup.
To display the environmental status of a particular MCS, use the following command:
user@host> show chassis environment mcs slot
To determine the status of the redundant MCS from the craft interface.
To display redundant MCS status from the craft interface, use the following CLI command:
user@host> show chassis craft-interface
user@host> show chassis craft-interface
FPM Display contents:
+--------------------+
|myrouter
|3 Alarms active
|R: Hard errors
|R: PEM 1 Input Fail |
+--------------------|
Front Panel System LEDs:
Routing Engine 0 1
--------------------------
OK * *
Fail . .
Master * .
Front Panel Alarm Indicators:
-----------------------------
Red LED *
Yellow LED *
Major relay *
Minor relay *
Front Panel FPC LEDs:
FPC 0 1 2 3 4
------------------------------------
Red * . . . *
Green . * . * .
MCS LEDs:
MCS 0 1
--------------
Amber . .
Green * *
8346 mV
12
command is available on the M40e and M160 routers
|
|
|
5 6 7
. . .
* * .
Chapter 35: Monitoring Redundant MCSs
, ,
Present Online
,
Offline
679