Verify Router Component Failure; Replace A Failed Component - Juniper M Series Monitoring And Troubleshooting Manual

Hide thumbs Also See for M Series:

Table of Contents

M Series and T Series Routers Monitoring and Troubleshooting Guide

Documentation

Verify Router Component Failure

Documentation

Sample Output

Jun 11 20:45:08 send: red alarm set, class 100 obj 112 reason 1

Jun 11 20:45:08 CIP removed

database provides the date, time, and a component status message. The

database is dynamic. It is initialized at router startup and is maintained when

components are added or removed. The command output displays error messages that

are generated when a Connector Interface Panel (CIP) fails or is removed.

Basic Router Component Monitoring Method on page 51

Checklist for Monitoring the Craft Interface on page 249

Display the Current Router Alarms on page 67

To verify router component failure by performing a swap test on the component.

Before performing a swap test, always check for bent pins in the

midplane and check the component for stuck pins in the connector. Pins

stuck in the component connector can damage other good slots during a

Perform a swap test on a component as follows:

Replace a failed component with one that you know works.

Verify the component status by using the appropriate

command. If the replaced component works, the original component is defective.

If the replaced component does not work, remove it and check the component

midplane connector for bent pins. If the replaced component still does not work,

contact JTAC.

Return the Failed Component on page 116

To return the router chassis, you need to know the chassis serial number. To display the

midplane serial number, use the following command:

user@host> show chassis hardware

show chassis hardware

show chassis hardwareItem

show chassis component-name

Serial number