Juniper M Series Monitoring And Troubleshooting Manual page 726

Hide thumbs Also See for M Series:

Table of Contents

M Series and T Series Routers Monitoring and Troubleshooting Guide

Documentation

The command shuts down the Routing Engine cleanly, so its state information is

Wait to continue until all software processes have shut down.

Flip the ends of the extractor clips outward.

Grasp the extractor clips and slide the unit about halfway out of the chassis.

Place one hand under the MCS to support it, slide it completely out of the chassis,

and place it on the antistatic mat or in the electrostatic bag.

Align the rear of the MCS with the guides inside the chassis and slide it in completely.

Press the extractor clips on the left and right sides of the MCS inward.

Verify that the green LED labeled

module LEDs on the craft interface to verify that the green LED labeled

for the host module to which the MCS belongs.

Verify correct MCS functioning by using the

If the replacement MCS works, you can be certain that the replaced MCS failed.

Checklist for Monitoring Redundant MCSs on page 675

on the MCS faceplate is lit. Also check the host

show chassis environment mcs