Figure 261: Scb Serial Number Id Label; Return The Scb - Juniper M Series Monitoring And Troubleshooting Manual

Display the SCB Firmware Version
Purpose
Action
Sample Output
Meaning
Related
Documentation

Return the SCB

Related
Documentation
Copyright © 2012, Juniper Networks, Inc.

Figure 261: SCB Serial Number ID Label

To display the firmware version running on the SCB.
To display the version of firmware running on the SCB, use the following CLI command:
user@host> show chassis firmware
user@host> show chassis firmware
Part
[...Output truncated...]
SCB 0
The command output displays the type and version level of the firmware running on the
SCB.
Checklist for Monitoring the SCB on page 491
The SCB is field-replaceable and hot-pluggable. You can remove and replace it without
powering down the system; however this causes major impact to the system. While the
SCB is out of the router, route lookups, system component monitoring, exception and
control packet transfer, and FPC operation monitoring cannot occur.
To return the SCB, see "Return the Failed Component" on page
Checklist for Monitoring the SCB on page 491
Type Version
ROM Juniper ROM Monitor Version 3.0b1
O/S Version 5.5-20020613-cqPqI7 by builder on 2
Chapter 22: Monitoring the SCB
116.
501