Obtain Feb Hardware Information; Display The Feb Hardware Information - Juniper M Series Monitoring And Troubleshooting Manual

Hide thumbs Also See for M Series:

Table of Contents

Documentation

Obtain FEB Hardware Information

Sample Output

of the extractor clips toward the outside edges of the router to release the Routing

Engine. Grasp both sides of the Routing Engine and slide it evenly out of the FEB.

Replace the Routing Engine in the FEB.

Align the rear of the unit with the guides inside the chassis. Slide the Routing Engine

all the way in until it contacts the connectors on the FEB. Flip the ends of the extractor

clips toward the center of the router to seat the Routing Engine onto the FEB. Using

a screwdriver, tighten the screws on the outside edges of the extractor clips. Slide the

Routing Engine into the slot evenly.

Use both hands to grasp the front of the replacement FEB that works and align the

rear of the FEB with the guides on the chassis.

To ensure proper seating of the ejector levers, move them to an outward position

slightly less than perpendicular to the faceplate before seating the FEB in the slot.

Slide the FEB all the way into the chassis until it contacts the midplane.

Grasp the ejector levers and carefully push the FEB to seat it onto the midplane.

Flip the ejector levers toward each other to lodge the FEB in place.

Checklist for Monitoring the FEB on page 553

To obtain FEB hardware information:

Display the FEB Hardware Information on page 559

Display the FEB Firmware Information on page 560

Locate the FEB Serial Number ID Label on page 560

To obtain information about the FEB hardware.

To display the FEB hardware information, use the following command:

user@host> show chassis hardware

Hardware inventory:

Power Supply A

Routing Engine

[...Output truncated...]

Serial number

a000000792cd0a01

Chapter 27: Monitoring the FEB

Internet Processor II