Display The Redundant Pcg Status From The Craft Interface - Juniper M Series Monitoring And Troubleshooting Manual

Display the Redundant PCG Status from the Craft Interface

Purpose
Action
Sample Output
Meaning
Copyright © 2012, Juniper Networks, Inc.
The command output is as follows:
PCG 0 status:
State
Temperature
Frequency:
Setting
Measurement
Power:
3.3 V
5.0 V bias
8.0 V bias
CMB Revision
PCG 1 status:
State
Temperature
Frequency:
Setting
Measurement
Power:
3.3 V
5.0 V bias
8.0 V bias
CMB Revision
The command output displays the status for each PCG. The operating status can be
, , , or
Present Online Offline Empty
or backup. The command output displays the temperature of the air flowing past the
PCG and the frequency setting and measurement for the PCG. The command output
also displays information about the PCG power supplies and the revision level of the
chassis management bus (CMB) backup.
To obtain redundant PCG status from the craft interface.
To display the PCG LED states, use the following command:
user@host> show chassis craft-interface
user@host> show chassis craft-interface
[...Output truncated...]
PCG LEDs:
PCG 0 1
--------------
Amber . .
Green * *
Blue * .
[...Output truncated...]
The command output is for an M160 router. The PCGs in slots 0 and 1 are online and are
functioning normally. The status colors represent the possible PCG operating states:
(Fail), (OK), and
Amber Green
state.
Chapter 37: Monitoring Redundant PCGs
Online - PFE clock source
41 degrees C / 105 degrees F
125.00 MHz
125.03 MHz
3266 mV
4981 mV
8168 mV
12
Online
39 degrees C / 102 degrees F
125.00 MHz
125.03 MHz
3271 mV
4971 mV
8175 mV
12
. If , it can be the current PFE clock source (master)
Online
(Master). The (*) indicates the current operating
Blue
707