Get Cip Hardware Information; Display Cip Hardware Information - Juniper M Series Monitoring And Troubleshooting Manual

Hide thumbs Also See for M Series:

Table of Contents

M Series and T Series Routers Monitoring and Troubleshooting Guide

Documentation

Get CIP Hardware Information

Sample Output

Carefully insert the CIP into the left side of the FPC card cage, following the guides

on the top and bottom of the card cage.

The components on the CIP are on the left side of the board, unlike

the components of an FPC, which are on the right side. Verify that the

components are on the left before inserting the CIP.

Slide the CIP into the chassis until it contacts the midplane.

Be sure to slide the CIP straight into the slot to avoid damaging

the connecting pins on the front of the midplane.

Tighten the screws on the top and bottom of the CIP faceplate.

Reattach any external devices connected to the CIP.

Power on the router. See the instructions in the M40e or M160 router hardware guide.

To verify that the CIP is installed correctly, plug an Ethernet cable into the CIP port

for the appropriate host module.

When the host module is operational, one of the activity indicator LEDs on the Ethernet

port (either the amber 10-Mbps LED or the green 100-Mbps LED) will flash to indicate

activity. If you can issue commands over the connection, the CIP is installed correctly.

Checklist for Monitoring the CIP on page 479

To get the CIP hardware information:

Display CIP Hardware Information on page 486

Locating the CIP Serial Number ID Label on page 487

To obtain the CIP hardware information.

To display the CIP hardware information, use the following command:

user@host> show chassis hardware

Hardware inventory:

Serial number