Bring The Replaced Pcg Online; Verify That The Replaced Pcg Is Online; Display The Replaced Pcg Environmental Status - Juniper M Series Monitoring And Troubleshooting Manual

Related
Documentation

Bring the Replaced PCG Online

Sample Output

Verify That the Replaced PCG Is Online

Display the Replaced PCG Environmental Status

Purpose
Action
Sample Output
Copyright © 2012, Juniper Networks, Inc.
CAUTION: Be careful to slide the PCG straight out of the chassis to avoid
bending any of the pins on the underside of the board.
Place one hand under the PCG to support it, slide it completely out of the chassis, and
7.
place it on the antistatic mat or in the electrostatic bag.
Slide the PCG all the way into the card cage until it contacts the midplane.
8.
Tighten the thumbscrew on the right side of the PCG faceplate.
9.
Verify that the PCG is properly installed by looking at the LEDs on the PCG faceplate.
10.
The green OK LED should light steadily.
Reinstall the rear component cover and tighten the thumbscrews on the corners of
11.
the cover to secure it to the chassis.
Checklist for Monitoring Redundant PCGs on page 703
To bring the replaced PCG online, use the following command:
user@host> request chassis pcg slot slot-number online
user@host> request chassis pcg slot 0 online
Online initiated, use 'show chassis environment pcg"
The PCG in slot 0 is brought online.
To verify that the replaced PCG is online:
Display the Replaced PCG Environmental Status on page 711
1.
2. Display PCG Messages in the System Log File on page 712
Display PCG Error Messages in the Chassis Daemon Log File on page 712
3.
To verify if the replaced PCG is online by checking the PCG environmental status.
To verify that the replaced PCG is online, use the following command:
user@host> show chassis environment pcg
user@host> show chassis environment pcg
PCG 0 status:
State
Temperature
Frequency:
Chapter 37: Monitoring Redundant PCGs
to verify
Online
30 degrees C / 86 degrees F
711