Table 121: Checklist For Monitoring The Cip; Cip Overview - Juniper M Series Monitoring And Troubleshooting Manual

M Series and T Series Routers Monitoring and Troubleshooting Guide
Related
Documentation

CIP Overview

480
Table 121: Checklist for Monitoring the CIP (continued)
Tasks for Monitoring the CIP
2. Check the Ethernet Port Functionality on
page 485
3. Perform a CIP Swap Test on page 485
"Get CIP Hardware Information" on page 486
1. Display CIP Hardware Information on
page 486
2. Locating the CIP Serial Number ID Label
on page 487
"Replace the CIP" on page 487
CIP Overview on page 480
Inspect the CIP to ensure connection to the Routing Engines, BITS interfaces for the MCS,
and alarm relay contacts.
The CIP provides an interface through which you can connect to the M40e and M160
Routing Engines, BITS interfaces for the MCS, and alarm relay contacts (see
on page 481).
Command or Action
1. Connect to the Ethernet port.
2. Check the LED.
LINK
3. Run the Junos OS CLI.
1. Power down the router.
2. Remove the CIP.
3. Replace the CIP with one that you know works.
4. Power on the router.
show chassis hardware
Look on the top of the left side of the CIP.
Power down the router. To replace and return a
CIP, follow the instructions in the M40e or M160
router hardware guide.
Copyright © 2012, Juniper Networks, Inc.
Figure 255