Juniper M Series Monitoring And Troubleshooting Manual page 138

M Series and T Series Routers Monitoring and Troubleshooting Guide
94
Table 32: T320 Router Chassis Component Alarm Conditions (continued)
Chassis
Component Alarm Condition
Alternative media The router boots from
alternate boot device: the
hard disk. Typically, the router
boots from the flash drive. If
you configure your router to
boot from the hard disk, ignore
this alarm condition.
Control Board A Control Board was removed.
A Control Board temperature
sensor alarm failed.
A Control Board failed.
CIP A CIP is missing.
Craft interface The craft interface failed.
Fan Trays One fan tray has been
removed from the chassis.
Two or more fan trays have
been removed from the
chassis.
One fan in the chassis is not
spinning or spinning below
require speed.
Alarm
Remedy Severity
For technical support, Yellow
open a support case
using the Case Manager
link at
http://www.juniper.net
/support/
or call
1-888-314-JTAC (within
the United States) or
1-408-745-9500
(outside the United
States).
Insert a Control Board Yellow
into an empty slot.
Replace the failed Yellow
Control Board.
Replace the failed Red
Control Board.
Insert a CIP into an Red
empty slot.
Replace the failed craft Red
interface.
Install the missing fan Yellow
tray.
Install the missing fan Red
trays.
Replace the fan tray. Red
Copyright © 2012, Juniper Networks, Inc.