Display The Pic Interface Status Information - Juniper M Series Monitoring And Troubleshooting Manual

M Series and T Series Routers Monitoring and Troubleshooting Guide

Display the PIC Interface Status Information

Purpose
Action
Sample Output
Meaning
240
State
PIC version
Uptime
PIC Port Information:
Port Cable
Number Type
0 OC48 SHORT REACH
1 UNKNOWN CABLE
2 UNKNOWN CABLE
3 UNKNOWN CABLE
To check the PIC media type and status for a particular FPC, use the
command.
pic-status fpc-slot
To display PIC hardware information, including the media type description, use the
command.
chassis hardware
show chassis fpc <pic-status <fpc-slot >>
show chassis hardware
To display the status information of each configured PIC interfaces.
To display the status of each configured interface, use the following operational mode
command:
user@host>show interfaces terse
user@host> show interfaces terse
Interface Adman Link Port Local
so-0/0/0 up up
so-0/0/0.0 up up
so-0/1/0 up down
so-0/1/1 up down
e1-0/2/0 up down
e1-0/2/1 up down
t1-1/0/0:1 up down
t1-1/0/0:2 up down
gr-2/0/0 up up
ip-2/0/0 up up
[...Output truncated...]
The command output shows the names of all interfaces configured on the router. The
interface name indicates the
whether the interface is on (
Additionally, the output shows the protocol configured on that interface and the local
address of the interface, as well as the address of the remote side of a connection for
point-to-point interfaces. Refer to the PIC for port numbering.
A line in the sample output shows the status of a SONET interface on FPC 0, PIC 0, port
0, and logical unit number 0. The status of the interface is
Online
1.1
7 days, 13 hours, 29 minutes, 51 seconds
SFP
Vendor Name
SumitomoElectric
inet 192.168.36.201
media type-fpc/pic/port (for example,
) or off ( ) and whether the link state is up or down.
up down
SFP Vendor
Part Number
SCP6828-J1-ANE
show chassis fpc
Remote
--> 192.168.36.200
so-0/0/0.0 ). It shows
. The link status is
up up
Copyright © 2012, Juniper Networks, Inc.
show
. The