Figure 117: Removing The Tx Matrix Plus Router Craft Interface; Locating The Craft Interface Serial Number Id Label - Juniper M Series Monitoring And Troubleshooting Manual

Related
Documentation

Locating the Craft Interface Serial Number ID Label

Locating the M20 Router Craft Interface Serial Number ID Label
Purpose
Action
Copyright © 2012, Juniper Networks, Inc.

Figure 117: Removing the TX Matrix Plus Router Craft Interface

Understanding the Craft Interface on page 252
If the craft interface has failed or is absent, it does not appear in the hardware list output
when you use the
show chassis hardware
and manually locate the craft interface serial number ID label.
NOTE: The M5 and M10 router craft interfaces are part of the chassis. You
cannot remove them.
To locate the craft interface serial number ID label, do one of the following:
Locating the M20 Router Craft Interface Serial Number ID Label on page 267
1.
Locating the M40 Router Craft Interface Serial Number ID Label on page 268
2.
3. Locating the M40e and M160 Router Craft Interface Serial Number ID Label on page 268
Locating the M120 Router Craft Interface Serial Number ID Label on page 269
4.
Locating the M320 Router Craft Interface Serial Number ID Label on page 269
5.
Locating the T320, T640, and T1600 Router Craft Interface Serial Number ID
6.
Label on page 270
Locating the TX Matrix Router Craft Interface Serial Number ID Label on page 270
7.
Locating the TX Matrix Plus Router Craft Interface Serial Number ID Label on page 271
8.
To locate the serial number ID on the M20 router craft interface.
To locate the M20 router craft interface serial number ID label, look at the back of the
craft interface panel (see Figure 118 on page
Chapter 9: Monitoring the Craft Interface
command. You must remove the craft interface
268).
267