Figure 202: Tx Matrix Router Control Board Component; Checking The Host Subsystem Status - Juniper M Series Monitoring And Troubleshooting Manual

Related
Documentation

Checking the Host Subsystem Status

Purpose
Action
Copyright © 2012, Juniper Networks, Inc.

Figure 202: TX Matrix Router Control Board Component

Routing Engine
ETHERNET ETHERNET
port ACT LED port speed LED
Y = 10/100
G = 1000
Status LEDs
ONLINE/OFFLINE
button
Checklist for Monitoring the Host Subsystem on page 367
To obtain the host subsystem status.
Each host subsystem has three LEDs that display its status. The host subsystem LEDs
are located on the right side of the craft interface.
To check the host subsystem status, use the following operational mode command:
user@host> show chassis craft-interface
To check the host subsystem status, use the following operational mode command:
user@host> show chassis craft-interface
Chapter 13: Monitoring the Host Subsystem
375