Table 94: M40E, M160, T320, And T640 Router Fpc Leds; Display The Pic Media Type - Juniper M Series Monitoring And Troubleshooting Manual

M Series and T Series Routers Monitoring and Troubleshooting Guide

Display the PIC Media Type

Purpose
Action
362
Table 93: M5, M10, and M20 Router PIC LEDs (continued)
Color State
None Not enabled
For M7i and M10i routers, check the LEDs on the PIC faceplates. Most PIC faceplates have
an LED labeled . Some PICs have additional LEDs, often one per port. The meaning
STATUS
of the LED states differs for various PICs. Each PIC has an LED on the FIC labeled
that shows whether the PIC is online.
ON/OFF
For M20 routers, if the FPC that houses the PIC detects a PIC failure, the FPC informs the
System and Switch Board (SSB), which in turn sends an alarm to the Routing Engine.
For M40 routers, each FPC has two LEDs that report its status as
are located below each FPC, on the craft interface. If there is a PIC failure, the
LED lights.
For M40e, M160, and T320 routers and T640 routers, each of the eight FPC slots in the
router has two LEDs and an offline button located directly above it on the craft interface.
The green LED labeled
OK
described in Table 94 on page
(for example, FPC4 ), prepares the FPC for removal from the router when pressed. Press
and hold the button for about 3 seconds until the
Each FPC slot has two LEDs that indicate its status. The FPC LEDs, labeled
FPC7 , are located along the bottom of the craft
the functions of the FPC LEDs. Each FPC also has a button that you use to take the FPC
offline and bring it online. The button is located next to the FPC LEDs on the bottom of
the craft interface.

Table 94: M40e, M160, T320, and T640 Router FPC LEDs

Label Color
OK Green
Red
FAIL
To display the PIC media type for FPCs installed in the router.
To display the PIC media type, use the following command:
user@host> show chassis fpc pic-status
Description
Port is not enabled.
and the red LED labeled
FAIL
362. The offline button, labeled with the FPC slot number
FAIL
interface.Table 94 on page 362
State Description
On steadily FPC is functioning normally.
Blinking FPC is starting up.
On steadily FPC has failed.
or . The LEDs
OK Fail
FPC Fail
indicate the FPC status, as
LED lights.
through
FPC0
describes
Copyright © 2012, Juniper Networks, Inc.
PICS