Display Sfm Alarms; Display Current Sfm Alarms - Juniper M Series Monitoring And Troubleshooting Manual

Related
Documentation

Display SFM Alarms

Display Current SFM Alarms

Purpose
Action
Sample Output
Copyright © 2012, Juniper Networks, Inc.
SPP temperature
SPR temperature
SPP Power:
1.5 V
2.5 V
3.3 V
5.0 V
5.0 V bias
SPR Power:
1.5 V
2.5 V
3.3 V
5.0 V
5.0 V bias
8.0 V bias
CMB Revision
SFM 1 status:
[...Output truncated...]
SFM 2 status:
[...Output truncated...]
SFM 3 status:
gm State
- Hard FPC error
[...Output truncated...]
The command output displays the SFM slot, status, and temperature of the air flowing
past the SPP card and the SPR card. It also displays information about the SFM power
supplies. The chassis management bus (CMB) backup revision level is also displayed.
You can display the environmental status of a particular SFM with the following command:
user@host> show chassis environment sfm sfm-slot
Checklist for Monitoring the SFMs on page 441
To display SFM alarms and error messages:
Display Current SFM Alarms on page 447
1.
Display SFM Error Messages in the System Log File on page 448
2.
Display SFM Error Messages in the Chassis Daemon Log File on page 448
3.
To determine the details of the current SFM alarms.
To display the current SFM alarms, use the following command:
user@host> show chassis alarms
user@host> show chassis alarms
36 degrees C / 96 degrees F
45 degrees C / 113 degrees F
1501 mV
2485 mV
3291 mV
5020 mV
4974 mV
1501 mV
2492 mV
3301 mV
5028 mV
4986 mV
8305 mV
12
Offline
Chapter 18: Monitoring the SFMs
447