CHAPTER 5
Cable and Rack Management
MX2020 Cable Manager Description
Standard Cable Management System
Copyright © 2015, Juniper Networks, Inc.
MX2020 Cable Manager Description on page 45
MX2020 Rack-Mounting Hardware on page 50
The MX2020 consists of a standard or extended cable management system.
Standard Cable Management System on page 45
Extended Cable Management System on page 48
The standard cable management system consists of the following components:
Upper cable manager—MX2000-CBL-TOP-S
Middle cable manager and air filter—MX2000-CBL-MID-S
Lower cable manager—MX2000-CBL-BTM-S
DC cable manager—MX2020-DC-CBL-MGR-S
The upper cable manager, (see
interface, has a removable cover that is secured by two captive screws with access to
rows used for routing and securing the cables away from the front of the Modular Port
Concentrators (MPCs), and Modular Interface Cards (MICs). The lower cable manager
(see
Figure 20 on page
46) is located just below the bottom line card cage, has a
removable cover that is secured by two captive screws with access to rows used for
routing and securing the cables away from the front of the MPCs, and MICs, (see
Figure 21 on page
47).
You can use cable strips or other ties to gently secure the cables in the upper and lower
cable manager. To secure the cables in place, loop the tie through the cable anchor and
secure the tie.
Each DC PDM has one cable manager. The DC cable manager routes cables away from
the rear of the PDMs (see
You can use cable strips or other ties to gently secure the cables in the DC cable manager.
To secure the cables in place, loop the tie through the cable anchor and secure the tie.
Figure 20 on page
46) is located just below the craft
Figure 20 on page
46).
45