Figure 303: M40 Router Redundant Power Supplies - Juniper M Series Monitoring And Troubleshooting Manual

Hide thumbs Also See for M Series:

Table of Contents

Figure 303: M40 Router Redundant Power Supplies

Documentation

M40e Router Power Supplies and Location

Checklist for Monitoring Redundant Power Supplies on page 607

The M40e router uses either AC or DC power. Two load-sharing, pass-through power

supplies are located at the bottom rear of the chassis.

M40e router power supplies and where they are installed in the chassis.

When the power supplies are installed and operational, they automatically share the

electrical load. If a power supply stops functioning for any reason, the remaining power

supplies instantly begin providing all the power the router needs for normal functioning,

and can provide full power indefinitely.

Chapter 30: Monitoring Redundant Power Supplies

Figure 304 on page 614