Table 133: Fic Interface Leds; Monitor The Fic Status; Display Fic Status At The Command Line; Check Fic Leds - Juniper M Series Monitoring And Troubleshooting Manual

M Series and T Series Routers Monitoring and Troubleshooting Guide

Monitor the FIC Status

Display FIC Status at the Command Line

Purpose
Action
Sample Output
Meaning

Check FIC LEDs

Purpose
Action
546
If the FIC fails, no information about chassis components is available through the CLI.
To monitor the FIC status:
1. Display FIC Status at the Command Line on page 546
Check FIC LEDs on page 546
2.
To display the FIC status at the command line.
To display the FIC status, use the following command:
user@host> show chassis pic pic-slot 3 fpc-slot 1
user@host> show chassis pic pic-slot 3 fpc-slot 1
PIC fpc slot 1 pic slot 3 information:
Type
ASIC type
State
PIC version
Uptime
PIC Port Information:
Port Cable
Number Type
0 UNKNOWN CABLE
Since the FIC is located in FPC 1 slot 3, you must specify its location with the
pic command. The command output displays the FIC information, such as the FIC type,
ASIC type, operating status, PIC version, and the amount of time the FIC has been online.
The command output also displays port cable information.
To monitor the FIC status by checking the FIC LEDs.
Table 133 on page 546describes the FIC interface LEDs located on the FIC faceplate.

Table 133: FIC Interface LEDs

Label Color
LINK Green
ACTIVITY Green
1x G/E, 1000 BASE
QGE FPGA
Online
1.4
12 hours, 11 minutes, 39 seconds
SFP
Vendor Name
State Description
On steadily The port is online.
Blinking The port is receiving data.
Off The port might be on, but is not receiving data.
Copyright © 2012, Juniper Networks, Inc.
SFP Vendor
Part Number
show chassis