Display Detailed Component Environmental Information - Juniper M Series Monitoring And Troubleshooting Manual

Hide thumbs Also See for M Series:

Table of Contents

Display Detailed Component Environmental Information

Table 22: Component LED Location on the Router (continued)

LED Location on the Router

(M40e and M160 routers) On the PCG faceplate at the rear of the

router. Remove the component cover.

(M40 router) On the SCB faceplate at the front of the router, vertical

in the middle of the FPC card cage.

(M20 router) On the SSB faceplate at the top front of the router.

Control Board

(T320, T640, and T1600 routers) On the Control Board faceplate at

the upper rear of the chassis.

M120 router: On the craft interface.

(TX Matrix and TX Matrix Plus routers) On the Control Board faceplate

at the rear of TX Matrix router and front of TX Matrix Plus router.

(T320, T640, and T1600 routers) On the SCG faceplate at the upper

rear of the chassis.

(M320, T320, T640, and T1600 routers) On the SIB faceplate at the

center rear of the chassis.

(TX Matrix and TX Matrix Plus routers) On the SIB faceplate at the

front of the chassis.

(M320 router) On the craft interface.

(M7i/M10i routers) On the DFEB faceplate at the rear of the router.

(M120 and M320 router) On the craft interface.

(M7i router) On the FIC faceplate at front of the router.

(M10i router) On the HCM faceplate at front of the router.

To check the component environmental information for the uptime to determine if it is

functioning properly.

To display detailed environmental status information about a component, use the

following command:

user@host> show chassis environment component-name

The command output displays the temperature of the air passing by the component, in

degrees Centigrade and Fahrenheit. It also displays whether the fans and/or blowers are

at normal or high speed.

Chapter 3: Method and Tools for Monitoring Router Components