Figure 255: Cip Component - Juniper M Series Monitoring And Troubleshooting Manual

Hide thumbs Also See for M Series:

Table of Contents

Figure 255: CIP Component

The CIP has two sets of ports you use to connect the Routing Engines to external

management devices. From these management devices, you can use the CLI to configure

and monitor the router.

The upper set of ports, labeled

the lower set of ports, labeled

port set includes the following ports:

—Connects the Routing Engine through an Ethernet connection to a

management LAN (or any other device that plugs into an Ethernet connection) for

out-of-band management. The port uses an autosensing RJ-45 connector to support

both 10-Mbps and 100-Mbps connections. Two small LEDs on the left edge of the port

indicate the connection in use: the yellow LED lights for a 10-Mbps connection and the

green LED lights for a 100-Mbps connection.

, connect to the Routing Engine in slot

Chapter 21: Monitoring the CIP