Monitoring The Sib Status - Juniper M Series Monitoring And Troubleshooting Manual

Hide thumbs Also See for M Series:

Table of Contents

Documentation

TX Matrix Plus Router SIBs

Documentation

Monitoring the SIB Status

Displaying the SIB Summary Status

Sample Output

and traffic forwarding continues without any degradation. When the failed component

is replaced, the data switching plane in which it resides becomes the new backup. If the

failed component is not replaced and a TX-SIB or T640-SIB in an active data switching

plane fails, only that component is taken offline.

Monitoring the SIBs on page 413

The TX Matrix Plus router contains TXP-F13 SIBs and TXP-F2S SIBs that connect together

through the midplane to create the switch fabric for the TX Matrix Plus router:

TXP-F13—Sixteen horizontal TXP-F13 SIB slots numbered 0 through 15 (top to bottom)

are located in the rear of the TX Matrix Plus router. A TXP-4 configuration contains ten

TXP-F13 SIBs, two for each data switching plane.

TXP-F2S—Twenty vertical TXP-F2S SIB slots are located in the front of the TX Matrix

Plus router. A TXP-4 configuration contains four TXP-F2 SIBs for each data switching

Monitoring the SIBs on page 413

To monitor the SIB status:

Displaying the SIB Summary Status on page 421

Displaying the SIB LED Status at the Command Line on page 422

Check the SIB LED Status on the Faceplate on page 422

Displaying the SIB Environmental Status on page 422

To obtain the SIB summary status.

To display the SIB summary status, use the following command:

user@host> show chassis sibs

show chassis sibs

4 hours, 5 minutes, 47 seconds

4 hours, 5 minutes, 42 seconds

4 hours, 5 minutes, 37 seconds

4 hours, 5 minutes, 33 seconds

Chapter 16: Monitoring the SIBs