General Commands; Terminal Commands; Clear Screen Command; Ping Command - Avaya P130 User Manual

Chapter 6 Avaya P130 CLI
• IP Route Configuration Commands
• PPP Commands
• Radius Commands
• RMON Commands
• SNMP Commands
• Policy-based Networking Commands

General Commands

Terminal Commands

Use the terminal width and terminal length commands to set the width and
length of the terminal display in characters.
The syntax for this command is:
terminal {width|length} [<characters>]

Clear screen Command

Use the clear screen command to clear the current terminal display.
The syntax for this command is:
clear screen

Ping Command

Use the ping command to send ICMP echo request packets to another node on the
network.
The syntax for this command is:
ping [host[number]]
host
number
Example:
To ping the IP number 149.49.48.1 ten times:
P130-N> ping 149.49.48.1 10
38
Host IP address/Internet address of route destination. If missing
then the last host IP is used.
Number of packets to send. If missing then the last number is used
Page 97
Page 99
Page 105
Page 108
Page 113
Page 119
Avaya P130 User's Guide