Note: When the stack master is the P332G-ML or P332GT-ML, if this command is to
be implemented on a module in the stack, a session should be opened to the
relevant module.
Show port self-loop-discovery Command
Use the show port self-loop-discovery command to display which port or
module has an enabled IBM™ token ring cable loop discovery status
The syntax for this command is:
show port self-loop-discovery [module num/port number]
Example:
P330-N> show port self-loop-discovery 1/5
Self-Loop-Discovery is enabled on port 1/5.
Note: When the stack master is the P332G-ML or P332GT-ML, if this command is to
be implemented on a module in the stack, a session should be opened to the
relevant module.
Show port auto-negotiation-flowcontrol-advertisement Command
Use the show port auto-negotiation-flowcontrol-advertisement
command to display the flowcontrol advertisement for a Gigabit port used to
perform auto-negotiation.
The syntax for this command is:
show port auto-negotiation-flowcontrol-advertisement
[<mod_num>[/<port_num>]]
mod_num
port num
Example:
P330-N> show port auto-negotiation-flowcontrol-advertisement
Port 1/1
Port 1/2
Port 1/3
Avaya P333R-LB User's Guide
Number of the module
Number of the port
advertises no flow control capabilities.
advertises no flow control capabilities.
advertises no flow control capabilities.
Chapter 5
Cajun Campus CLI – Layer 2
63