Mitsubishi 3000GT Service Manual page 269

INSPECTION
Using Scan tool
HARNESS INSPECTION
Engine control module
harness side connector
On-Vehicle Inspection of MFI
FUEL INJECTION - Components
Measure the power supply volt-
l
- Connector: Disconnected
Ignition switch: ON
Battery voltage
Check for an open-circuit, or a
short-circuit to ground between
the EGR
control module.
EGR solenoid connector: Dis-
connected
Engine control module con-
l
nector: Disconnected
ACTUATOR INSPECTION
Refer to GROUP 17 - Exhaust Gas Recirculation (EGR) Sys-
tem.
the engine
relay)
Repair the
harness.