Mitsubishi 3000GT Service Manual page 240

INSPECTION
Using Scan Tool
HARNESS INSPECTION
A Harness side
MULTIPORT On-Vehicle Inspection of MFI
FUEL INJECTION - Components
Data display Check condition
Sensor
Engine: Warmed up
temperature
Engine is maintained in
a constant state for
2 minutes or more
Disconnect vacuum
hose (green stripe) from
EGR solenoid and install
blind caps to removed
vacuum hose end and
solenoid nipple.
Connector: Disconnected
l
Ignition switch: ON
Connector: Disconnected
l
SENSOR INSPECTION
Refer to GROUP' 17 - Exhaust Gas Recirculation (EGR) Sys-
tem.
TSB Revision
Engine state
Standard value
700 rpm (Idle) 100°C (212°F) or less
3,500 rpm 120°C (248°F) or more