Powering On An Ac-Powered M10I Router - Juniper M10i Hardware Manual

M10i Multiservice Edge Router Hardware Guide

Powering On an AC-Powered M10i Router

66
All manuals and user guides at all-guides.com
To power on the router:
Verify that the power supplies are fully inserted in the chassis and the thumbscrews
1.
on their faceplates are tightened.
Verify that the ends of each AC power cord are firmly plugged into the appliance inlet
2.
on the power supply faceplate and the external power source receptacle.
Verify that an external management device is connected to one of the Routing Engine
3.
ports ( ,
AUX/MODEM CONSOLE
NOTE: The Ethernet
initial router software configuration after the router is powered on for the
first time. You can monitor the startup process during the initial installation
using devices connected to the
Turn on the power to the external management device.
4.
Press the power switch on the faceplate of the power supplies in slots
5.
to the ( ) position.
1 ON |
NOTE: After a power supply is powered on, it can take up to 60 seconds
for status indicators—such as LEDs on the power supply and command
display output—to indicate that the power supply is functioning normally.
Ignore error indicators that appear during the first 60 seconds.
NOTE: If the LED does not light after 60 seconds, verify that the power
supply is properly inserted into the chassis and repeat the cable installation
procedures described in "Connecting Power on an AC-Powered M10i
Router" on page 65.
NOTE: The Routing Engine boots as the power supply completes its startup
sequence. If the Routing Engine finishes booting and you need to power
off the router again, see "Powering Off an M10i Router" on page 71.
Verify that the
OUTPUT OK
6.
steadily.
Press the power switch for any additional power supplies to the
7.
verify that the
OUTPUT OK
On the external management device connected to the Routing Engine, monitor the
8.
startup process to verify that the system has booted properly.
, or ).
MGMT
port is not available until you complete the
MGMT
AUX/MODEM
LED on each power supply faceplate eventually lights
LED on each power supply faceplate lights steadily.
Copyright © 2010, Juniper Networks, Inc.
or CONSOLE ports.
and
P/S 0 P/S
( ) position and
ON |