Removing The Router; Powering Off An Acx5000 Router - Juniper ACX5048 Manual

CHAPTER 14

Removing the Router

Powering Off an ACX5000 Router

Copyright © 2015, Juniper Networks, Inc.
Powering Off an ACX5000 Router on page 129
Removing an ACX5000 Router from a Rack or Cabinet on page 131
Before you power off an ACX5000 router:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge
(ESD) damage. See Prevention of Electrostatic Discharge Damage.
Ensure that you do not need to forward traffic through the router.
Ensure that you have the following parts and tools available to power off the router:
An ESD grounding strap
An external management device such as a PC
An RJ-45 to DB-9 rollover cable to connect the external management device to the
console port
To power off an ACX5000 router:
Connect to the router using one of the following methods:
1.
Connect a management device to the console (
For instructions about connecting a management device to the console (
see "Connecting an ACX5000 Router to a Management Console" on page
You can shut down the ACX5000 router from a management device on your
out-of-band management network. For instructions about connecting a
management device to the management (
ACX5000 Router to a Network for Out-of-Band Management" on page
Shut down Junos OS from the external management device by issuing the
2.
operational mode CLI command. This command shuts down the router
system halt
gracefully and preserves system state information. A message appears on the console,
confirming that the operating system has halted.
You see the following output (or something similar, depending on the hardware being
shut down) after entering the command:
) port on an ACX5000 router.
CON
or ) port, see "Connecting an
CO C1
) port,
CON
121.
122.
request
129