Powering On The Ln2600 Router - Juniper LN2600 Hardware Manual

LN2600 Rugged Security Router Hardware Guide
Related
Documentation

Powering on the LN2600 Router

22
To remove the router from the 19 in. rack:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Using the screwdriver, loosen the four cage nuts from the front and from the rear of
2.
the rack that hold the LN2600 router.
Ensure that you hold the router from the bottom for support before loosening the
nuts.
Hold the LN2600 router from the bottom to support it, and pull it completely out of
3.
the rack.
To remove the router from the wall-mounting unit:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Using the screwdriver, loosen the four clamps from the top and bottom of the
2.
wall-mounting unit that holds the LN2600 router to the wall-mounting unit.
Using the screwdriver, remove the eight nuts from the side of the heat sink unit.
3.
Using the screwdriver, remove the two screws from the top center of the LN2600
4.
router.
Hold the LN2600 router from the bottom for support, and pull it completely out of
5.
the wall-mounting unit.
Mounting the LN2600 Router on the Wall on page 18
Mounting the LN2600 Router on the Rack on page 14
The LN2600 router derives its power from a single -48 VDC power supply with dual power
inputs.
CAUTION: The LN2600 router has more than one power source. Ensure
proper care while connecting the DC power supply to the router.
You connect DC power to the router by attaching power cables from the external DC
power sources to the terminal on the power supply ports. The power cables are not
provided with the router.
Copyright © 2015, Juniper Networks, Inc.