Related
Documentation
Replacing an M320 Control Board
Removing an M320 Control Board
Copyright © 2015, Juniper Networks, Inc.
Pressing firmly on both ends, push the module into the slot until the ejectors return
5.
completely to the closed position.
Install the Routing Engine. See
6.
You can view the SDRAM configuration and verify the DIMM was installed correctly
7.
by issuing the
show chassis routing-engine
Figure 90: Installing the DIMM Module
M320 Routing Engine Description on page 24
Replacing an M320 Routing Engine on page 216
Preventing Electrostatic Discharge Damage to an M320 Router on page 318
Removing an M320 Control Board on page 223
1.
Installing an M320 Control Board on page 225
2.
The router can have one or two CBs. They are located in the upper rear of the chassis in
the slots marked
and
CB0
Chapter 26: Replacing Host Subsystem Components
"Installing an M320 Routing Engine" on page
command.
. Each weighs approximately 3.4 lb (1.5 kg).
CB1
217.
223