Installing A Compactflash Card In A Ptx5000 Routing Engine; Figure 249: Removing A Routing Engine Compactflash Card - Juniper PTX5000 Hardware Manual

PTX5000 Packet Transport Router Hardware Guide

Installing a CompactFlash Card in a PTX5000 Routing Engine

394
Remove the cover from the Routing Engine slots by loosening the captive screws on
7.
the corners of the cover (using a number 2 Phillips (+) screwdriver).
CAUTION: Do not remove the cover if any of the LEDs are lit.
Press the eject button on the right side of the CompactFlash card slot to release the
8.
CompactFlash card.
The CompactFlash card pops partially out of the slot. Grasp the card and pull it
9.
completely out of the slot.
Place the CompactFlash card on the antistatic mat.
10.

Figure 249: Removing a Routing Engine CompactFlash Card

To install a CompactFlash card (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the cover from the Routing Engine slots by loosening the captive screws on
2.
the corners of the cover (using a number 2 Phillips (+) screwdriver).
Insert the CompactFlash card into the CompactFlash card slot on the Routing Engine,
3.
with the logo facing up.
CAUTION: Be sure to insert the CompactFlash card with the label facing
up. Inserting the CompactFlash card incorrectly might damage the Routing
Engine.
Press the card firmly all the way into the slot.
4.
Figure 250 on page 395):
Copyright © 2017, Juniper Networks, Inc.