Installing Or Removing A Ctp2000 Series Compactflash Card - Juniper CTP2000 Series Hardware Documentation

CTP2000 Hardware Documentation
Related
Documentation

Installing or Removing a CTP2000 Series CompactFlash Card

90
CAUTION: If you do not use the halt command before powering down the
CTP device, the CompactFlash card might become corrupted.
To remove a CTP module:
Issue the halt command.
1.
Ground yourself by using an antistatic wrist strap or other device, and connect it to
2.
an ESD grounding jack, if available, or another grounding device.
Use a Philips screwdriver to loosen the captive screws located at the top and bottom
3.
of the module panel.
If the module has ejector handles, press the red release buttons, and pull the ejector
4.
handles outward to the open position.
Carefully slide the module out of the chassis.
5.
Place the module in its antistatic bag, being careful not to touch module components,
6.
pins, leads or solder connections.
Cover the empty chassis slot with a blank filler panel, and tighten the filler panel's
7.
captive screws using a Phillips screwdriver. Turn both screws several times before
tightening them completely.
Installing a CTP Interface Module, Processor Module, or Clock Module on page 89
On the CTP2000 series devices with the new PP833 processor, the CompactFlash card
is installed on the processor itself (which may be located under an installed PMC card),
which prevents insertion or removal of the CompactFlash card until the PMC card is
removed. On the CTP2000 series devices with the PP310 and PP332 processors, the
CompactFlash card is installed on the processor rear transition module (RTM). Some
CTP devices may ship with a CompactFlash card already installed.
To remove or install the CompactFlash card for the CTP2000 series with the new PP833
processor (see Figure 34 on page
Power off the unit.
1.
If installed, remove the PP833 PMC card by unscrewing the retaining screws and
2.
pushing the extractors outward with the latching buttons depressed.
You can then remove or install the CompactFlash card in the flash socket.
3.
If being used, reinstall the PP833 PMC card into the chassis, and secure the retaining
4.
screws.
91):
Copyright © 2017, Juniper Networks, Inc.