Replacing The Compactflash Card In An M10I Routing Engine; Removing The Compactflash Card From An M10I Routing Engine; Installing The Compactflash Card In An M10I Routing Engine; Figure 57: Removing The Compactflash Card - Juniper M10i Hardware Manual

Replacing the CompactFlash Card in an M10i Routing Engine

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
The CompactFlash card is an optional component of the Routing Engine 400 and a
standard component of the Routing Engine 850. If installed, it provides primary storage
for the router. It accommodates software images, configuration files, and microcode.
To remove, install, and configure a CompactFlash card, perform the following procedures:
Removing the CompactFlash Card from an M10i Routing Engine on page 137
Installing the CompactFlash Card in an M10i Routing Engine on page 137

Removing the CompactFlash Card from an M10i Routing Engine

The CompactFlash card is located inside the Routing Engine. To remove the CompactFlash
card (see Figure 57 on page 137):
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Remove the Routing Engine as described in "Replacing the M10i Routing Engine" on
3.
page 131.
Use needlenose pliers with grooved jaws to pull the wire clasp out from under the
4.
CompactFlash card and lift it up (see Figure 57 on page 137).
Use the needlenose pliers to gently grasp the CompactFlash card and slide it out of
5.
the connector. Place the CompactFlash card on the antistatic mat or in the electrostatic
bag.

Figure 57: Removing the CompactFlash Card

CompactFlash card

Installing the CompactFlash Card in an M10i Routing Engine

To install the CompactFlash card (see Figure 58 on page 138):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If the CompactFlash card is in a PCMCIA card adapter, slide it out of the adapter.
2.
Chapter 15: Replacing M10i Hardware Components
Routing Engine (front)
Wire clasp
137