Installing An M10I Ac Power Supply; Figure 47: Removing An Ac Power Supply - Juniper M10i Hardware Manual

M10i Multiservice Edge Router Hardware Guide
122
All manuals and user guides at all-guides.com

Figure 47: Removing an AC Power Supply

Installing an M10i AC Power Supply

To install an AC power supply (see Figure 48 on page 123):
Verify that the switch on the power supply faceplate is in the
1.
Locate the AC power cord shipped with the router, which should be appropriate for
2.
your geographical location (see "M10i AC Power Cord Specifications" on page 189).
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Grasp the handle on the power supply faceplate with one hand and place the other
4.
hand under the supply to support it.
Align the rear of the supply with the slide guides inside the chassis and slide the supply
5.
into the chassis until it contacts the midplane.
Tighten (but do not overtighten) the thumbscrews on the power supply faceplate.
6.
Insert the appliance coupler end of the AC power cord into the appliance inlet on the
7.
power supply faceplate and insert the plug into an AC power source receptacle. Verify
that the AC power cord does not block access to router components or drape where
people could trip on it.
Press the power switch on the faceplate to the
8.
supply has powered on successfully, the green
( ) position.
OFF O
( ) position. When the power
ON |
LED lights steadily.
OUTPUT OK
Copyright © 2010, Juniper Networks, Inc.