Installing An Acx4000 Ac Power Supply - Juniper ACX4000 Hardware Manual

SEE ALSO
Connecting AC Power Cords to the ACX4000 Router | 102
ACX4000 AC Power Specifications | 61
ACX4000 AC Power Cord Specifications | 62

Installing an ACX4000 AC Power Supply

To install an AC power supply (see
1. Attach an ESD grounding strap to your bare wrist, and connect the other end of the strap to an ESD
grounding point.
2. Using both hands, slide the power supply straight into the chassis until the power supply is fully
seated in the chassis slot. The power supply faceplate should be flush with any adjacent power
supply faceplate or blank installed in the power supply slot.
3. Attach the power cord to the power supply.
4. Attach the power cord to the AC power source, and switch on the dedicated customer site circuit
breaker. Follow the instructions for your site.
Observe the status LED on the power supply faceplate. If the power supply is correctly installed and
functioning normally, the status LED lights green steadily.
Figure 37: Installing an AC Power Supply
SEE ALSO
Connecting AC Power Cords to the ACX4000 Router | 102
ACX4000 AC Power Specifications | 61
ACX4000 AC Power Cord Specifications | 62
Figure 13):
142