Installing A Ptx5000 Ac Psm; Figure 214: Removing A Psm - Juniper PTX5000 Hardware Manual

Packet transport router

Hide thumbs Also See for PTX5000:

Table of Contents

Installing a PTX5000 AC PSM

Grasp the ejector handle and pull to eject the PSM. Slide it halfway out of the chassis

Figure 214 on page

Each AC PSM weighs approximately 10.5 lb (4.8 kg). Be

prepared to support the full weight of the PSM as you remove it from the

packet transport router.

Place one hand underneath the PSM to support it and slide it completely out of the

To install an AC PSM:

Using both hands, slide the PSM into the chassis until you feel resistance . Each AC

PSM weighs approximately 10.5 lb (4.8 kg).

Push the ejector handle toward the PSM, and tighten the captive screw on the PSM.

Verify that the

PSM is receiving power.

Verify that the

Chapter 27: Removing and Installing Power System Components

LED on the PSM faceplate is lit steadily, indicating that the

LED on the PSM faceplate is lit steadily.

Table of Contents