Viewing The Status Of Dynamic Bgp Routes - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
Router ID
5. Configure autonomous system path filters. For more information, refer to
Autonomous System Path
6. Configure prefix list filters. For more information, refer to
7. Configure route map filters. For more information, refer to
8. Configure a network. For more information, refer to
9. Configure IP addresses for neighbors. For more information, refer to
10. Configure aggregate addresses. For more information, refer to
Address".
11. Configure redistribution metrics. For more information, refer to
Metric".
12. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
13. Click Exit Transaction or continue making changes.
Section 5.19.2

Viewing the Status of Dynamic BGP Routes

To view the status of the dynamic BGP routes configured on the device, navigate to routing » status » bgp »
route. If BGP routes have been configured, the Route table appears.
Figure 484: Route Table
The Route table provides the following information:
Parameter
Network
To view the routing information advertised to the network, navigate to routing » status » bgp » neighbor »
advertised-route. The Advertised Route table appears.
438
Description
Router ID for BGP.
Filter".
Description
Network.
Section 5.19.6.3, "Adding an
Section 5.19.5.3, "Adding a Prefix
Section 5.19.3.3, "Adding a Route Map
Section 5.19.8.2, "Adding a
Section 5.19.7.2, "Adding a
Section 5.19.9.2, "Adding an Aggregate
Section 5.19.11.2, "Adding a Redistribution
Viewing the Status of Dynamic BGP Routes
RUGGEDCOM ROX II
User Guide
List".
Filter".
Network".
Neighbor".