Managing Route Maps; Viewing A List Of Route Map Filters - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
1
Figure 597: OSPF Area Table
1. Add Button 2. Edit Button
3. Click Delete next to the chosen area.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.21.6

Managing Route Maps

Route maps are sequential statements used to filter routes that meet the defined criteria. If a route meets
the criteria of the applied route map, it can either be excluded from the routing table or prevented from being
redistributed. In ROX II, route maps are configured to filter routes based on their metric value, which defines the
cost of the route. Once a match is found, the assigned action is taken.
Each route map requires a sequence number (e.g. 10, 20, 30, etc.), which allows for multiple route maps to be
run in sequence until a match is found. It is recommended to create sequence numbers in intervals of 10, in case
a new route map is required later between two existing route maps.
The following sections describe how to configure and manage route maps for OSPF:
• Section 5.21.6.1, "Viewing a List of Route Map Filters"
• Section 5.21.6.2, "Viewing a List of Route Map Filter Entries"
• Section 5.21.6.3, "Adding a Route Map Filter"
• Section 5.21.6.4, "Adding a Route Map Filter Entry"
• Section 5.21.6.5, "Deleting a Routing Map Filter"
• Section 5.21.6.6, "Deleting a Routing Map Filter Entry"
• Section 5.21.6.7, "Configuring Match Rules"
Section 5.21.6.1

Viewing a List of Route Map Filters

To view a list of route map filters for either dynamic OSPF routes, navigate to routing » dynamic » ospf » filter »
route-map. If filters have been configured, the Route Map table appears.
520
2 3
3. Delete Button
RUGGEDCOM ROX II
User Guide
Managing Route Maps