Configuring The Source Zone - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
description
7. Configure the source zone for the policy. For more information, refer to
Source Zone".
8. Configure the destination zone for the policy. For more information, refer to
the Destination
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
9.
to proceed.
10. Click Exit Transaction or continue making changes.
Section 5.17.11.3

Configuring the Source Zone

To configure the source zone for a firewall policy, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to security » firewall » fwconfig » {firewall} » fwpolicy{policy} » source-zone, where {firewall}
is the name of the firewall and {policy} is the name of the policy. The Source Zone form appears.
Figure 427: Source Zone Form
1. Pre-Defined Zone List
3. Configure the following parameter(s) as required:
Parameter
predefined-zone
all
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
390
Description
(Optional) The description string for this policy.
Zone".
2. All Check Box
Description
Section 5.17.11.3, "Configuring the
Section 5.17.11.4, "Configuring
Configuring the Source Zone
RUGGEDCOM ROX II
User Guide