Managing Ipv4 Addresses; Viewing A List Of Ipv4 Addresses; Adding An Ipv4 Address - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Section 5.38.3

Managing IPv4 Addresses

The following sections describe how to configure and manage IPv4 addresses:
• Section 5.38.3.1, "Viewing a List of IPv4 Addresses"
• Section 5.38.3.2, "Adding an IPv4 Address"
• Section 5.38.3.3, "Deleting an IPv4 Address"
Section 5.38.3.1

Viewing a List of IPv4 Addresses

To view a list of IPv4 address for a routable interface, navigate to ip » {interface} » ipv4, where {interface} is the
name of the routable interface. If addresses have been configured, the Addresses table appears.
Figure 912: Addresses Table
If no addresses have been configured, add addresses as needed. For more information, refer to
"Adding an IPv4 Address".
Section 5.38.3.2

Adding an IPv4 Address

To add an IPv4 address to a routable interface, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
Navigate to ip » {interface} » ipv4, where {interface} is the name of the routable interface.
2.
3. Click <Add address>. The Key Settings form appears.
792
RUGGEDCOM ROX II
User Guide
Section 5.38.3.2,
Managing IPv4 Addresses