Adding An Snmp Security Model - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Figure 280: SNMP Security Model to Group Mapping Table
If no SNMP security models have been configured, add security models as needed. For more information, refer to
Section 5.11.8.2, "Adding an SNMP Security
Section 5.11.8.2

Adding an SNMP Security Model

To add an SNMP security model, do the following:
Change the mode to Edit Private or Edit Exclusive.
1.
2. Navigate to admin » snmp » snmp-security-to-group and click <Add snmp-security-to-group>. The Key
Settings form appears.
Figure 281: Key Settings Form
1. Security Model List
3. Configure the following parameter(s) as required:
Parameter
Security Model
User Name
Click Add to create the protocol. The SNMP Security Model to Group Mapping screen appears.
4.
Adding an SNMP Security Model
Model".
1
2
2. User Name List 3. Add Button
Description
Synopsis: v1, v2c, v3
The SNMP security model to use: SNMPv1, SNMPv2c, or USM/SNMPv3.
The security name (a ROX user name) for the SNMP group.
Chapter 5
Setup and Configuration
3
273