Deleting An Egress Interface; Managing Ethernet Types For Generic Tunnels - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
6.
to proceed.
7. Click Exit Transaction or continue making changes.
Section 5.29.9.3

Deleting an Egress Interface

To delete an egress interface for a generic tunnel, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to tunnel » l2tunneld » generic » {name} » remote-daemon » egress-if, where {name} is the
name of the generic tunnel. The Generic L2 Tunnel Egress Interface table appears.
1
Figure 778: Generic L2 Tunnel Egress Interface Table
1. Add Button 2. Edit Button
3. Click Delete next to the chosen egress interface.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.29.10

Managing Ethernet Types for Generic Tunnels

The following sections describe how to configure and manage Ethernet types for generic tunnels:
• Section 5.29.10.1, "Viewing a List of Ethernet Types"
• Section 5.29.10.2, "Adding an Ethernet Type"
• Section 5.29.10.3, "Deleting an Ethernet Type"
660
2 3
3. Delete Button
RUGGEDCOM ROX II
User Guide
Deleting an Egress Interface