Siemens RX1500 User Manual page 433

RUGGEDCOM ROX II
User Guide
Figure 440: Main Rule Settings Form
1. Action List 2. Source Zone Hosts Box
Box 7. Destination Port Box
6. Configure the following parameter(s) as required:
NOTE
When applying new rules, previous traffic seen by the router might still be considered as having
valid connections by the connection tracking table. For instance:
. A rule for the TCP and UDP protocols is applied.
. The router sees both TCP and UDP traffic that qualifies for NAT.
. The rule is then modified to allow only UDP.
Adding a Rule
3. Destination Zone Hosts Box
8. Original Destination Box
4. Log Level List
9. Description Box
Setup and Configuration
5. Protocol Box 6. Source Port
Chapter 5
401