Deleting A Neighbor - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
Parameter
in
out
6. On the Neighbor form, configure the following parameter(s) as required:
Parameter
Neighbor Autonomous System ID
ebgp-multihop
Maximum Prefix
next-hop-self
password
update-source
disable-connected-check
soft-reconfiguration
weight
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 5.19.7.3

Deleting a Neighbor

To delete a neighbor from a BGP network, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » bgp » neighbor. The Neighbor table appears.
1
Figure 524: Neighbor Table
1. Add Button
3. Click Delete next to the chosen neighbor.
Deleting a Neighbor
Description
Apply route map to incoming routes.
Apply route map to outbound routes.
Description
A BGP neighbor.
The maximum hop count. This allows EBGP neighbors not on directly connected
networks.
The maximum prefix number accepted from this peer.
Disables the next hop calculation for this neighbor.
Password.
Source IP address of routing updates.
Disables connection verification when establishing an eBGP peering session with a
single-hop peer that uses a loopback interface.
Per neighbor soft reconfiguration.
The default weight for routes from this neighbor.
2. Edit Button 3. Delete Button
Chapter 5
Setup and Configuration
2
3
465