Managing Network Interfaces; Viewing A List Of Network Interfaces - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » rip » network » ip. The Subnet table appears.
1
Figure 555: Subnet Table
1. Add Button
3. Click Delete next to the chosen IP address.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.20.6

Managing Network Interfaces

The following sections describe how to configure and manage interfaces for a RIP network:
• Section 5.20.6.1, "Viewing a List of Network Interfaces"
• Section 5.20.6.2, "Adding a Network Interface"
• Section 5.20.6.3, "Deleting a Network Interface"
Section 5.20.6.1

Viewing a List of Network Interfaces

To view a list of interfaces configured for a RIP network, navigate to routing » dynamic » rip » network »
interface. If interfaces have been configured, the Interface table appears.
Figure 556: Interface Table
If no interfaces have been configured, add neighbors as needed. For more information, refer to
"Adding a Neighbor".
Managing Network Interfaces
2 3
2. Edit Button 3. Delete Button
Chapter 5
Setup and Configuration
Section 5.20.7.2,
489