Deleting A Masquerade Or Snat Setting - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Parameter
Outgoing Interface Specifics
IP Alias
Source Hosts
SNAT Address
description
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 5.17.13.3

Deleting a Masquerade or SNAT Setting

To delete a masquerade or SNAT setting, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to security » firewall » fwconfig » {firewall} » fwmasq, where {firewall} is the name of the
firewall. The Net Address Translation Main Settings table appears.
1
Figure 437: Net Address Translation Main Settings Table
1. Add Button 2. Edit Button
3. Click Delete next to the chosen masquerade or SNAT setting.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
398
Description
(Optional) An outgoing interface list - specific IP destinations for the out-interface.
Create IP Alias for NAT rule.
Subnet range or comma-separated list of hosts (IPs)
(Optional) By specifying an address here, SNAT will be used and this will be the source
address.
(Optional) The description string for this masq entry.
3. Delete Button
RUGGEDCOM ROX II
2
Deleting a Masquerade or SNAT Setting
User Guide
3