Viewing A List Of Interfaces For Ipv4 Static Routes; Adding An Interface For An Ipv4 Static Route - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 634: Static Route Using Interface Form
1. Interface Name Box
4. Configure the following parameter(s) as required:
Parameter
Interface Name
Distance (optional)
Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
5.
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.22.7.2

Viewing a List of Interfaces for IPv4 Static Routes

To view a list of interfaces assigned to an IPv4 static route, navigate to routing » static » ipv4 » {subnet} » dev,
where subnet is the subnet (network/prefix) of the static route. If interfaces have been configured, the Static
Route Using Interface table appears.
Figure 635: Static Route Using Interface Table
If no interfaces have been configured, add interfaces as needed. For more information, refer to
"Adding an Interface for an IPv4 Static
Section 5.22.7.3

Adding an Interface for an IPv4 Static Route

To add an interface for an IPv4 static route, do the following:
546
1
2
2. Distance Box
Description
The interface for the static route.
The distance for the static route.
Route".
Viewing a List of Interfaces for IPv4 Static Routes
RUGGEDCOM ROX II
User Guide
Section 5.22.7.3,