Configuring The Internal Vlan Range - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
3. Configure the following parameter(s) as required:
Parameter
IP Address Source
ProxyARP
on-demand
mtu
4. Add Quality of Service (QoS) maps to the VLAN. For more information, refer to
QoS Map".
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.35.3

Configuring the Internal VLAN Range

ROX II creates and utilizes internal VLANs for internal functions. To provide ROX II with a pool of VLAN IDs to
pull from when creating internal VLANs, a range of VLAN IDs must be reserved.
CAUTION!
Configuration hazard – risk of data loss. If the range-start or range-end values are changed in a way
that invalidates any configured internal VLANs, the configurations defined for the affected VLANs will
be lost upon repositioning.
IMPORTANT!
VLAN IDs reserved for internal VLANs should not be used by the network.
NOTE
Changing the End of Range value repositions the matching serial VLAN. However, the matching serial
VLAN is not affected when the Start of Range value is changed.
NOTE
If no internal VLANs are available when a switched Ethernet or trunk port is configured, the range is
automatically extended so a unique value can be assigned.
NOTE
Routable Ethernet ports and trunks cannot be configured if internal VLANS are not enabled.
732
Description
Synopsis: static, dynamic
Whether the IP address is static or dynamically assigned via Dynamic Host
Configuration Protocol (DHCP) or Bootstrap Protocol (BOOTP). The DYNAMIC option is
a common case of a dynamically assigned IP address. It switches between BOOTP and
DHCP until it gets the response from the relevant server. This must be static for non-
management interfaces.
Enables/Disables whether the VLAN will respond to ARP requests for hosts other than
itself.
Brings up this interface on demand only.
Default: 1500
The maximum transmission unit (the largest packet size allowed for this interface).
RUGGEDCOM ROX II
User Guide
Section 5.37.7.2, "Adding a
Configuring the Internal VLAN Range