Adding An Snmp Target Address - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 272: SNMPv3 Target Configuration Table
If no SNMP target addresses have been configured, add target addresses as needed. For more information, refer
to Section 5.11.6.2, "Adding an SNMP Target
Section 5.11.6.2

Adding an SNMP Target Address

To add an SNMP target adress, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin » snmp » snmp-target-address and click <Add snmp-target-address>. The Key
Settings form appears.
Figure 273: Key Settings Form
1. Target Name Box
3. Configure the following parameter(s) as required:
Parameter
Target Name
4. Click Add to create the protocol. The SNMPv3 Target Configuration screen appears.
266
Address".
1
2. Add Button
Description
A descriptive name for the target (ie. 'Corportate NMS').
RUGGEDCOM ROX II
User Guide
2
Adding an SNMP Target Address