Deleting A Connection - Siemens RX1500 User Manual

RUGGEDCOM ROX II
User Guide
NOTE
The timeout period must be two minutes longer than the interval period.
Parameter
Enable
Interval
Timeout
Action
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
Click Exit Transaction or continue making changes.
5.
Section 5.28.6.4

Deleting a Connection

To delete a connection for a VPN, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to tunnel » ipsec » connection. The Connection table appears.
1
Figure 729: Connection Table
1. Add Button
3. Click Delete next to the chosen connection.
Deleting a Connection
Description
Default: false
Enables Dead Peer Detection (DPD) for this connection.
Default: 30
The interval (in seconds) between Dead Peer Detection keepalive messages sent for
this connection when no traffic (idle) appears to be sent by a DPD enabled peer.
Default: 120
The time in seconds to wait before a peer is declared dead.
Prerequisite: The timeout period must be more than two times the interval.
Synopsis: hold, clear, restart, restart-all-sa
Default: restart
The action to be taken when a DPD enabled peer is declared dead. Options include:
• hold: The route will be put on hold status.
• clear: The route and Security Association (SA) will both be cleared
• restart: The SA will immediately be renegotiated
• restart-all-sa: All SA's to the dead peer will be renegotiated
2. Edit Button 3. Delete Button
Chapter 5
Setup and Configuration
2
3
625